Hi all, I like Valentina Studio very much. But when I work with Postgres 13 and try to parse a PLpgSQL-Function, I get problems with the Analyser of Valentina Studio. It says
12:1: Error: Alter command should specify what object to alter.
Then I can't change to another tab and the whole SQL-Tab is out of control. And that even I use the 'execute selection'-Button. The alter command is below the PLpgSQL-Script outside the selection.
A second problem is $$ ... $$ or $BODY$ ... $BODY$. Between these strings is no highlighting in the script. Will you try to change this? It would be very nice!
Best regards
Helmut
-
Helmut Starr
- Valentina Studio
- Четверг, Декабрь 15 2022, 10:32 AM
- Подписаться через email
Комментарий
There are no comments made yet.
Ivan Smahin
Ответ принят
Ruslan Zasukhin
Ответ принят
Hi Helmut,
thank you for your 2 tasks for us
About the ALTER. Can you add here an example of that FUNC + ALTER command after it?
May be you can easily invent "fake SQL lines", if your SQL is private. Or, report this into Mantis, and there you can add a private note.
thank you for your 2 tasks for us
About the ALTER. Can you add here an example of that FUNC + ALTER command after it?
May be you can easily invent "fake SQL lines", if your SQL is private. Or, report this into Mantis, and there you can add a private note.
- Страница :
- 1
There are no replies made for this post yet.
However, you are not allowed to reply to this post.
However, you are not allowed to reply to this post.